Error message

SPLC program binary code of CC has changed

Cause of error

The binary code of the SPLC program has been changed, although the source code has remained unchanged. Possible causes:
- New SPLC compiler through software update
- Corrupted binary file of the SPLC program for CC (without software update)
The CRC sum of the SPLC program binary code of the CC differs from the entry in the safe machine parameter SMP691.2.

Error correction

Message appears after a software update:
Delete the error message, then restart the control and run the required partial acceptance test.
Then take the new CRC sum into the corresponding safe machine parameters.
Message appears, although no software update has been conducted:
Inform your service agency.