Program Continuation:

NC code identifier %1 cannot be reconfigured to %2

%1 = String: Old identifier %2 = String: New identifier

Renaming of an NC code was not possible for one of the following reasons:

The old identifier does not exist

The new identifier is within another type range.

NC codes/keywords can be reconfigured as long as you stay within the type range.

Type 1: "true" G codes: G02, G17, G33, G64, ...

Type 2: named G codes: ASPLINE, BRISK, TRANS, ...

Type 3: addresses which can be set: X, Y, A1, A2, I, J, K, ALF, MEAS, ...

-    NC not ready.

-    Mode group not ready, also effective for single axes

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm.

Please inform the authorized personnel/service department. Correct machine data 10712: NC_USER_CODE_CONF_NAME_TAB (protection level 1).

The list must be built up as follows:

Even address: Identifier to be modified Following odd address: New identifier e.g.: NC_USER_CODE_CONF_NAME_TAB [10] = "ROT",

NC_USER_CODE_CONF_NAME_TAB [11] = " " clears the ROT function from the control Switch control OFF - ON.


© Siemens AG 2005 All Rights Reserved