4340

Parameters:


Definitions:


Reactions:


Remedy:

Program Continuation:


Channel %1 block %2 invalid transformation type in transformation no. %3

%1 = Channel number %2 = Block number, label %3 = Transformation number

An invalid, i.e. undefined, number was entered in one of the machine data TRAFO_TYPE_1 ... TRAFO_TYPE_8. This alarm also occurs if a certain type of transformation is only impossible on the type of control used (e.g. 5-axis transformation on a SINUMERIK 802D).

-    Correction block is reorganized.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm at block end.

Enter a valid transformation type.

Clear alarm with the RESET key. Restart part program


© Siemens AG 2005 All Rights Reserved


1-132