Channel %1 tool move not possible. Magazine no. %2 not available.
%1 = Channel ID %2 = Magazine number
The desired tool motion command - triggered from the MMC or PLC - is not possible. The magazine with the specified number is not available.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Check whether the magazine data have been defined correctly.
If the PLC issued the command for motion: check whether the PLC program is correct.
If the MMC issued the command for motion: check whether the MMC command was assigned correct parameters.
Clear alarm with the Delete key or NC START.
© Siemens AG 2005 All Rights Reserved