6423

Channel %1 tool move not possible. Location %2 on magazine %3 not available.

Parameters:

%1 = Channel ID

Definitions:

%2 = Magazine location number %3 = Magazine number

The desired tool motion command - triggered from the MMC or PLC - is not possible. The specified magazine location is not contained in the specified magazine.

Reactions:

- NC Start disable in this channel.

Remedy:

Program Continuation:

-    Interface signals are set.

-    Alarm display.

Check whether the magazine data have been defined correctly.

Clear alarm with the Delete key or NC START.

© Siemens AG 2005 All Rights Reserved

1-170