Program Continuation:

Channel %1 tool %2 cannot be placed in magazine %3 on location %4. Invalid definition of magazine!

%1 = Channel ID %2 = String (identifier)

%3 = Magazine number

%4 = Magazine location number

The desired tool motion command - triggered from the MMC or PLC - is not possible. A movement request was issued to put the tool in a location which does not satisfy the prerequisites for filling.

The following causes for the error are possible:

Location is blocked or not free!

Tool type does not match the location type!

Tool possibly too large, adjacent locations are not free!

If a tool is to be loaded or unloaded, the load/unload position must be of 'load location' type.

If a tool is to be loaded or unloaded, is the magazine in question linked to the load/unload location?

See $TC_MDP1, $TC_MDP2.

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

Check whether the magazine data have been defined correctly.

Check whether there is still room in the magazine to add another tool; there may not be due to operating procedures.

Check whether a location type hierarchy is defined and whether it, for example, does not allow insertion of a type 'A' tool in a free location with type 'B'.

Check whether the magazine in question is linked to the load/unload location or whether a distance has been defined.

Check whether the load/unload position is of 'load location' type.

See also $TC_MPP1.

Clear alarm with the Delete key or NC START.

© Siemens AG 2005 All Rights Reserved