6431

Parameters:

Definitions:

Reactions:

Remedy:


Program Continuation:


Channel %1 block %2 Function not allowed. Tool management/monitoring is not active.

%1 = Channel ID

%2 = Block number, label

Occurs when a data management function is called which is not available because ToolMan is deactivated. For example, the language commands GETT, SETPIECE, GETSELT, NEWT, DELT.

-    Correction block is reorganized.

-    Interface signals are set.

-    Alarm display.

Please inform the authorized personnel/service department.

Make sure of how the NC is supposed to be configured! Is tool management or tool monitoring needed but not activated?

Are you using a part program that is meant for a numerical control with tool management/ tool monitoring? It is not possible to start this program on the numerical control without tool management/tool monitoring. Either run the part program on the appropriate NC control or edit the part program.

Activate tool management/tool monitoring by setting the appropriate machine data. See $MN_MM_TOOL_MANAGEMENT_MASK, $MC_TOOL_MANAGEMENT_MASK Check whether the required option is set accordingly.

Clear alarm with NC START or RESET key and continue the program.


© Siemens AG 2005 All Rights Reserved


1-174