Channel %1 block %2 tool change not possible. No assignment between toolholder/spindle no. = %3 and buffer magazine location %4
%1 = Channel ID
%2 = Block number, label
%3 = Spindle no.
%4 = Location no.
The desired tool change is not possible. No relation has been defined between the toolholder/spindle number and the buffer magazine location (Location No.)
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Check whether the magazine data ($TC_MLSR) have been defined correctly.
Check whether the alarm-causing program command _ e.g. TCI _ has been programmed correctly.
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved