8030

Parameters:

Definitions:

Reactions:

Remedy:

Program Continuation:

Channel %1 block %2 option 'interpolation of more than 4 axes' not set

%1 = Channel number %2 = Block number, label

The option for the number of interpolating axes does not correspond to the number of axes programmed in the interpolation group.

-    Interpreter stop

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

Option: "Interpolation of more than 4 axes" (the number of axes that is then allowed can be set in this option) or specify in the part program as many (or fewer, as required) axes corresponding to the configuration of the control.

Clear alarm with the RESET key. Restart part program

1-228

© Siemens AG 2005 All Rights Reserved