10754


Parameters:

Definitions:


Reactions:


Remedy:

Program Continuation:


Channel %1 block %2 deselection of the tool radius compensation only possible in linear block

%1 = Channel number %2 = Block number, label

Deselection of cutter radius compensation with G40 can only be performed in blocks where the G function G00 (rapid traverse) or G01 (feed) is active.

In the block with G40, at least one axis in the plane G17 to G19 must be written. It is always advisable to write both axes because, as a rule, both axes are traversed when deselecting the compensation.

-    Correction block is reorganized.

-    Local alarm reaction.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm at block end.

Correct the NC program and put the compensation selection in a block with linear interpolation.

Clear alarm with NC START or RESET key and continue the program.


1-329


© Siemens AG 2005 All Rights Reserved