10757

Channel %1 block %2 changing the compensation plane while tool radius compensation is active not possible

Parameters:

%1 = Channel number

%2 = Block number, label

Definitions:

In order to change the compensation plane (G17, G18 or G19) it is first necessary to deselect the cutter radius compensation with G40.

Reactions:

-    Correction block is reorganized.

-    Local alarm reaction.

Remedy:

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm at block end.

Insert an intermediate block in the part program using the correction deselection. After the plane change, the cutter radius compensation is to be selected in an approach block with linear interpolation.

Program Continuation:

Clear alarm with NC START or RESET key and continue the program.

© Siemens AG 2005 All Rights Reserved

1-332