Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 illegal interpolation type during linear programming with angles
%1 = Channel number %2 = Block number, label
Only spline or linear interpolation is permitted for programming two straight lines with angle specification. Circular or polynomial interpolation is not allowed.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved