Program Continuation:

Channel %1 block %2 activation of chamfers or radii (non-modal) without traversing movement in the block

%1 = Channel number %2 = Block number, label

No chamfer or radius has been inserted between 2 linear or circle contours (edge breaking) because:

There is no straight line or circle contour in the plane There is a movement outside of the plane A plane change has taken place

The permissible number of dummy blocks without traversing information has been exceeded.

-    Correction block is reorganized.

-    Local alarm reaction.

-    Interface signals are set.

-    Alarm display.

Please inform the authorized personnel/service department. Correct the part program according to the above error description or change the number of dummy blocks in the channel-specific MD CHFRND_MAXNUM_DUMMY_BLOCKS to comply with the maximum number allowed for in the program.

Clear alarm with NC START or RESET key and continue the program.


© Siemens AG 2005 All Rights Reserved