10942

Parameters:


Definitions:


Reactions:


Remedy:

Program Continuation:


Channel %1 block %2 curve table %3: illegal instruction during definition

%1 = Channel number %2 = Block number, label %3 = Number of curve table

Various illegal command sequences cause the output of this alarm during the definition of the curve table. For example, it is impermissible to terminate definition of a curve table with M30 before programming the CTABEND command.

-    Interpreter stop

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

Correct the part program and start it again.

Clear alarm with the RESET key. Restart part program


1-393


© Siemens AG 2005 All Rights Reserved