10947

Parameters:


Definitions:

Reactions:


Remedy:

Program Continuation:


Channel %1 block %2 curve table %3: contour not continuous

%1 = Channel number %2 = Block number, label %3 = Number of curve table

The contour in a curve table must be continuous. Incontinuity can occur, for example, as a result of activating a transformation.

-    Interpreter stop

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

Correct the part program and start it again.

Clear alarm with the RESET key. Restart part program


© Siemens AG 2005 All Rights Reserved


1-398