10955

Parameters:


Definitions:


Reactions:

Remedy:

Program Continuation:


Channel %1 block %2 curve table %3: missing master axis motion

%1 = Channel number %2 = Block number, label %3 = Number of curve table

A slave axis motion has been programmed without a master axis motion. This can also occur if, with active radius compensation, a block is created in which the slave axis moves but not the master axis. The alarm is for information only and can be suppressed by setting MD $MC_CTAB_ENABLE_NO_LEADMOTION = 2.

- Alarm display.

Alarm can be switched off via MD $MC_CTAB_ENABLE_NO_LEADMOTION = 2.

Clear alarm with NC START or RESET key and continue the program.


1-403


© Siemens AG 2005 All Rights Reserved