12700 |
Channel %1 block %2 contour definition programming not allowed as modal subprograms active |
Parameters: |
%1 = Channel number %2 = Block number, label |
Definitions: |
In the external language mode, a block is programmed with contour definition and a modal cycle is active at the same time. Because of unclear address assignment (e.g. R = radius for contour definition or return plane for drilling cycle) contour definition programming must not be used when a modal cycle is active. |
Reactions: |
- Correction block |
Remedy: Program Continuation: |
- Interface signals are set. - Alarm display. Modify part program. Clear alarm with NC START or RESET key and continue the program. |
© Siemens AG 2005 All Rights Reserved