14036

Parameters:

Definitions:

Reactions:

Remedy:

Program Continuation:

Channel %1 block %2 involute: end point invalid

%1 = Channel number %2 = Block number, label

With involute interpolation, the end point of the involute must be outside the basic circle. The programmed center point / radius or end point must be adapted accordingly.

-    Correction block is reorganized.

-    Interface signals are set.

-    Alarm display.

Modify part program.

Clear alarm with NC START or RESET key and continue the program.

1-527

© Siemens AG 2005 All Rights Reserved