14122

Parameters:

Definitions:

Reactions:

Remedy:

Program Continuation:

Channel %1 block %2 angle and direction of the cone programmed

%1 = Channel number %2 = Block number, label

With taper circumference interpolation of orientation with ORICONCW and ORICC, only the opening angle or the direction of the taper may be programmed. Programming of both in one single block is not allowed.

-    Correction block is reorganized.

-    Interface signals are set.

-    Alarm display.

Modify part program.

Clear alarm with NC START or RESET key and continue the program.

1-568

© Siemens AG 2005 All Rights Reserved