14134 |
Channel %1 block %2 G code for orientation interpolation not allowed |
Parameters: |
%1 = Channel number %2 = Block number, label |
Definitions: |
It will only be possible to program a G code of the 51st G code group, if machine data ORI_IPO_WITH_G_CODE has been set to TRUE. |
Reactions: |
- Interpreter stop - NC Start disable in this channel. |
Remedy: Program Continuation: |
- Interface signals are set. - Alarm display. Adapt machine data. Clear alarm with the RESET key. Restart part program |
© Siemens AG 2005 All Rights Reserved