14270

Channel %1 block %2 pole programmed incorrectly

Parameters:

%1 = Channel number

%2 = Block number, label

Definitions:

When defining the pole, an axis was programmed that does not belong to the selected processing level. Programming in polar coordinates always refers to the plane activated with G17 to G19. This also applies to the definition of a new pole with G110, G111 or G112.

Reactions:

-    Correction block is reorganized.

-    Interface signals are set.

-    Alarm display.

Remedy:

Correct the NC part program. Only the two geometry axes may be programmed that establish the current machining plane.

Program Continuation:

Clear alarm with NC START or RESET key and continue the program.

© Siemens AG 2005 All Rights Reserved

1-614