Channel %1 block %2 GEOAX function: incorrect call
%1 = Channel number %2 = Block number, label
The parameters for the GEOAX(...) call are incorrect. Possible causes:
Uneven number of parameters.
More than 6 parameters were specified.
A geometry axis number was programmed which was smaller than 0 or greater than 3. A geometry number was programmed more than once.
An axis identifier was programmed more than once.
An attempt was made to assign a channel axis to a geometry axis which has the same name as one of the channel axes.
An attempt was made to remove a geometry axis from the geometry axis grouping and the geometry axis has the same name as one of the channel axes.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Modify part program or correction block.
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved