14822

Parameters:

Definitions:


Reactions:


Remedy:


Program Continuation:


Channel %1 block %2 incorrect programming of GWPS

%1 = Channel number %2 = Block number, label

When selecting GWPS (constant grinding wheel peripheral speed) with GWPSON or programming the GWPS with "S[spindle number] = value" one of the following errors has occurred:

Invalid spindle number.

Invalid parameter number for radius calculation in $TC_TPG9.

The following values are valid:

3    for $TC_DP3 (length 1)

4    for $TC_DP4 (length 2)

5    for $TC_DP5 (length 3)

6    for $TC_DP6 (radius)

Invalid angle in $TC_TPG8.

The following values are valid: -90 <= $TC_TPG8 < +90.

A grinding wheel radius equal to zero was specified.

-    Correction block is reorganized.

-    Interface signals are set.

-    Alarm display.

Check tool compensation data.

$TC_DP1 : 400 - 499.

$TC_TPG1: Spindle number.

$TC_TPG8: Inclination angle for slope grinding wheel.

$TC_TPG9: Compensation parameters for radius computation, e.g. 3 for $TC_GP3. Clear alarm with NC START or RESET key and continue the program.


1-697


© Siemens AG 2005 All Rights Reserved