Channel %1 block %2 error on selection or deselection of tool monitoring
%1 = Channel number %2 = Block number, label
On selecting tool monitoring with TMON, one of the following errors occurred:
Selection does not refer to a grinding-specific tool (400-499).
Selection refers to an invalid spindle number.
An attempt has been made to select tool monitoring for a spindle that is already assigned to another tool by TMON, GWPSON, CLGON or activation of tool length compensation. An attempt has been made to select a tool that has not been defined.
An attempt has been made to select an edge (implicitely) that has not been defined. (Implicit selection: D1 of a tool, if no edge has been specified.)
An attempt has been made to select tool monitoring for the active tool, although no tool length compensation has been activated.
Invalid parameter number for radius calculation in $TC_TPG9.
The following values are valid:
3 for $TC_DP3 (length 1)
4 for $TC_DP4 (length 2)
5 for $TC_DP5 (length 3)
6 for $TC_DP6 (radius)
A grinding wheel radius equal to zero has been specified.
On deselecting tool monitoring with TMOF, one of the following errors occurred: Deselection does not refer to a grinding-specific tool (400-499).
An attempt has been made to deselect tool monitoring for the active tool, although tool length compensation is not active.
Deselection refers to an invalid spindle number.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Check TMON and TMOF command.
Check tool compensation data.
$TC_DP1 : 400 - 499.
$TC_TPG1: Spindle number.
$TC_TPG8: Inclination angle for slope grinding wheel.
$TC_TPG9: Parameter number for radius computation, e.g. 3 for $TC_GP3.
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved