14900

Parameters:

Definitions:

Reactions:

Remedy:

Program Continuation:

Channel %1 block %2 center point and end point programmed simultaneously

%1 = Channel number %2 = Block number, label

When programming a circle by means of the opening angle, the circle center point was programmed together with the circle end point. This is too much information for the circle. Only one of the two points is allowed.

-    Correction block is reorganized.

-    Interface signals are set.

-    Alarm display.

Select the programming variant guaranteeing that the dimensions are definitely taken over from the workpiece drawing (avoidance of calculation errors).

Clear alarm with NC START or RESET key and continue the program.

1-702

© Siemens AG 2005 All Rights Reserved