14910

Parameters:

Definitions:

Reactions:

Remedy:

Program Continuation:

Channel %1 block %2 invalid angle of aperture for programmed circle

%1 = Channel number %2 = Block number, label

When programming a circle by means of the opening angle, a negative opening angle or an opening angle greater than or equal to 360 degrees has been programmed.

-    Correction block is reorganized.

-    Interface signals are set.

-    Alarm display.

Program opening angle within the allowed range of values between 0.0001 and 359.9999 [degrees].

Clear alarm with NC START or RESET key and continue the program.

1-703

© Siemens AG 2005 All Rights Reserved