16020

Parameters:

Definitions:


Reactions:


Remedy:

Program Continuation:


Channel %1 repositioning in block %2 is not possible

%1 = Channel number

%2 = Block number, label

Programming or operator action incorrect:

Repositioning via REPOS command is only possible in an asynchronous subprogram (interrupt routine).

If the REPOS command was programmed, e.g. in the main program or in a cycle, part program execution is aborted with alarm 16020.

In addition, the alarm is output in the following situations:

Access to $AC_RETPOINT (repositioning point) outside an ASUP (e.g. in the main program)

An axis to be repositioned was a oscillating axis with sychronous infeed (OSCILL) in the interrupted block and is now in a state that does not allow it to be traversed as a oscillating axis. Remedy: Change the axis to "neutral axis" state before repositioning with WAITP.

An axis to be repositioned was an infeed axis for a oscillating axis in the interrupted block; now it can no longer be traversed as one. Remedy: Change the axis back to "POS axis" state before repositioning.

-    Interpreter stop

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

Modify the part program if necessary.

Clear alarm with the RESET key. Restart part program


© Siemens AG 2005 All Rights Reserved


1-758