16130

Channel %1 block %2 instruction not allowed with FTOCON

Parameters:

%1 = Channel number

%2 = Block number, label

Definitions:

Case 1: A plane change is not allowed if the modal G function FTOCON: "fine tool compensation" is active.

Case 2: Transformation selection is allowed only for zero transformation or transformation inclined axis, Transmit or Tracyl if FTOCON is active.

Case 3: Tool change is not allowed with M06 if FTOCON has been active since the last tool change.

Case 4: Orientable tool holder is active.

Reactions:

-    Correction block is reorganized.

-    Interface signals are set.

-    Alarm display.

Remedy:

Program Continuation:

Modify part program: Deselect fine tool compensation with FTOCOF.

Clear alarm with NC START or RESET key and continue the program.

© Siemens AG 2005 All Rights Reserved

1-766