16200
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
Channel %1 block %2 spline and polynominal interpolation not available
%1 = Channel number %2 = Block number, label
The spline and polynomial interpolation are options that are not contained in the basic version of the control.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Do not program spline and polynomial interpolation, or retrofit the necessary option. Clear alarm with NC START or RESET key and continue the program.
1-769
© Siemens AG 2005 All Rights Reserved