Channel %1 block %2 axis %3 programmed speed is illegal (zero or negative)
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
A spindle speed (S value) was programmed with the value zero or with a negative value.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
The programmed spindle speed (S value) must be positive. Depending on the application case, the value zero can be accepted (e.g. G25 S0).
Clear alarm with NC START or RESET key and continue the program.
© Siemens AG 2005 All Rights Reserved