16820

Parameters:

Definitions:

Reactions:

Remedy:


Program Continuation:


Channel %1 block %2 traverse instruction ACN for axis %3 not allowed

%1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

The keyword ACN (Absolute Coordinate Negative) is only allowed for "modulo axes". It causes approach of the programmed absolute position in the specified direction.

-    Interpreter stop

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

Please inform the authorized personnel/service department. In the displayed NC block, replace the keyword ACN by specifying AC (Absolute Coordinate).

If the alarm display is based on an incorrect axis definition, the axis with the axis-specific MD 30300: IS_ROT_AX and MD 30310: ROT_IS_MODULO can be declared a rotary axis with modulo change.

Corresponding machine data:

Modify MD 30320: DISPLAY_IS_MODULO

Clear alarm with the RESET key. Restart part program


© Siemens AG 2005 All Rights Reserved


1-828