Channel %1 interrupt treatment: action %2<ALNX> not possible due to stop


%1 = Channel ID

%2 = Action number/action name


Reorg events are, e.g. abort subprogram, delete distance to go and interrupts, axis replacement, termination of follow-up mode. Two Reorg events overlap in this situation. The 2nd Reorg event coincides with the 1st block generated by the previous event. (e.g. an axis replacement is induced twice in rapid succession). Axis replacement leads to Reorg in the channels in which an axis is removed without preparation. This block must be stopped in the above sequence in order to prevent the interpolator buffer from overflowing. This can be achieved by pressing the Stop or StopAll key, configuring an alarm with INTERPRETERSTOP or by decode single block.


- NC Start disable in this channel.


Program Continuation:

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm.

The program must be aborted with Reset.

Clear alarm with the RESET key. Restart part program

© Siemens AG 2005 All Rights Reserved