20077

Parameters:


Definitions:


Reactions:


Remedy:


Program Continuation:


Channel %1 axis %2 programmed position is behind software limit switch %3

%1 = Channel number %2 = Axis number %3 = "+" or "-"

The axis is traversed as an oscillating axis and the target position (reversal position or end position) is located behind the corresponding software limit switch. The axis is not traversed.

-    Local alarm reaction.

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm.

Specify smaller target position.

Modify MD for SW limit switch.

Possibly activate another SW limit switch.

Clear alarm with the RESET key. Restart part program


© Siemens AG 2005 All Rights Reserved


1-998