20201

Parameters:

Definitions:

Reactions:

Remedy:

Program Continuation:

Channel %1 spindle %2 no tool assigned

%1 = Channel number %2 = Spindle number

In order to make allowance for the fine tool compensation for the tool currently in the spindle, a spindle/tool assignment must be active. This is not presently the case for the programmed spindle in the target channel of fine tool compensation.

-    Interpreter stop

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm.

1.    Modify the part program (write the tool fine compensation).

2.    Establish spindle/tool assignment by programming:

TMON (tool monitoring)

GWPSON (tool selection)

Clear alarm with the RESET key. Restart part program

1-1042

© Siemens AG 2005 All Rights Reserved