21660

Parameters:

Definitions:

Reactions:

Remedy:

Program Continuation:

Channel %1 block %2 axis %3 conflict between SYNACT: $AA_OFF and CORROF

%1 = Channel number %2 = Block number, label %3 = Axis name

When deselecting the position offset ($AA_OFF) via the part program command CORROF (<axis>, "AA_OFF") an active synchronized action is detected that immediately sets $AA_OFF for the axis (DO_$AA_OFF [<axis>] =<value>). Deselection is executed and $AA_OFF not set again.

-    Correction block is reorganized.

-    Local alarm reaction.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm at block end.

Modify part program.

Clear alarm with NC START or RESET key and continue the program.

1-1061

© Siemens AG 2005 All Rights Reserved