22065

Channel %1 tool management: Tool motion is not possible, as tool %2 with Duplo no. %3 is not in magazine %4

Parameters:

%1 = Channel number

Definitions:

%2 = String (identifier)

%3 = Duplo no.

%4 = Magazine no.

The desired tool motion command - triggered from the MMC or PLC - is not possible. The specified tool is not contained in the specified magazine. (NCK cannot contain tools that are not assigned to a magazine. With this kind of tool, no operations (motion, change) can be performed.)

Reactions:

- NC Start disable in this channel.

Remedy:

-    Interface signals are set.

-    Alarm display.

Check that the specified tool is contained in the desired magazine, or program another tool to be changed.

Program Continuation:

Clear alarm with the Delete key or NC START.

© Siemens AG 2005 All Rights Reserved

1-1100