26022

Parameters:

Definitions:

Reactions:


Remedy:


Program Continuation:


Axis %1 encoder %2 measurement with simulated encoder not possible

%1 = NC axis number %2 = Encoder number

Alarm occurs on the control when a measurement was made without the encoder hardware (simulated encoder).

-    Local alarm reaction.

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm.

Please inform the authorized personnel/service department. If possible, modify the measuring motion such that the axis concerned does not have to travel; do not program this axis in the MEAS block again. However, it is then no longer possible to query a measured value for this axis.

Ensure that measurement is not taking place with simulated encoders (MD $MA_ENC_TYPE).

Clear alarm with the RESET key. Restart part program


1-1161


© Siemens AG 2005 All Rights Reserved