61113

Parameters:

Definitions:

Reactions:


Remedy:

Program Continuation:


Channel %1 Block %2: Parameter _CRAD too large for corner radius

%1 = Channel number %2 = Block number, label

The parameter for the corner radius _CRAD has been specified too large. Alarm triggered by following cycle: POCKET3.

-    Alarm display.

-    Interface signals are set.

-    NC Start disable in this channel.

-    Interpreter stop Parameter must be reduced.

Clear alarm with the RESET key. Restart part program


© Siemens AG 2005 All Rights Reserved


1-1322