61124

Parameters:

Definitions:

Reactions:


Remedy:

Program Continuation:


Channel %1 Block %2: Infeed width is not programmed

%1 = Channel number

%2 = Block number, label

Alarm triggered by following cycle: CYCLE71.

-    Alarm display.

-    Interface signals are set.

-    NC Start disable in this channel.

-    Interpreter stop

With active simulation without tool, a value for the infeed width _MIDA must always be programmed.

Clear alarm with the RESET key. Restart part program


1-1333


© Siemens AG 2005 All Rights Reserved