Reactions:
Remedy:
Program Continuation:
Channel %1 Block %2: Tool change point lies within retraction area!
%1 = Channel number %2 = Block number, label
The tool change point has to be far enough outside the retraction area so that when the revolver is swiveled, no tool extends into the retraction area.
The alarm is triggered by the following cycle: F_SP_RP
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Specify another tool change point.
Clear alarm with the RESET key. Restart part program
© Siemens AG 2005 All Rights Reserved