Reactions:
Remedy:
Program Continuation:
Channel %1 CLC position offset at lower limit %2
%1 = Channel number %2 = Limit value
The position offset generated by the overlaid motion has reached the limit set in MD $MC_CLC_SENSOR_LOWER_LIMIT or programmed with CLC_LIM(...,...). Depending on the setting in bit 0 of MD $MC_CLC_SPECIAL_FEATURE_MASK the following cancel criterion applies:
Bit 0 = 0: Cancel key Bit 0 = 1: Reset key
- NC Start disable in this channel.
- Alarm display.
- NC Stop on alarm.
Check position and form of the workpiece. If necessary, program further limits.
Clear alarm with the Delete key or NC START.
© Siemens AG 2005 All Rights Reserved