Axis %1 drive %2 measuring circuit %3 is not available
%1 = NC axis number
%2 = Drive number
%3 = Measuring circuit number
In the axis-specific MD 30230 ENC_INPUT_NR [e]=E (e ... encoder index - the position control works with this encoder, E ... encoder number - encoder connector selection on the drive module), an encoder connector (1 or 2) was selected, to which no encoder is connected.
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Configure MD 30230 ENC_INPUT_NR [e] according to the encoder connector used or plug the encoder cable onto the other connector.
If the encoder used corresponds to the input in the MD, there is a hardware fault on the drive module. Replace the module!
Switch control OFF - ON.
© Siemens AG 2005 All Rights Reserved