Axis %1 drive %2 monitoring cycle times of both axes differ
%1 = NC axis number %2 = Drive number
The monitoring cycles set in MD 1300: $MD_SAFETY_CYCLE_TIME (monitoring cycle) for the two axes of a 2-axis module are not identical.
Request: During boot-up of the control.
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department. Check and, if necessary, correct MD 1300: $MD_SAFETY_CYCLE_TIME (monitoring cycle) on all drives of the module.
Switch control OFF - ON.
© Siemens AG 2005 All Rights Reserved