300789

Parameters:

Definitions:


Reactions:


Remedy:

Program Continuation:


Axis %1 drive %2 function not supported on this 611D controller module

%1 = NC axis number %2 = Drive number

A function was selected that is not possible with this closed-loop control module. This alarm appears, if:

a non-available acceleration sensor was activated in MD 1560.

-    NC not ready.

-    The NC switches to follow-up mode.

-    Channel not ready.

-    NC Start disable in this channel.

-    Interface signals are set.

-    Alarm display.

-    NC Stop on alarm.

-    Channel not ready.

Switch off the non-selectable function or use another closed-loop control module! Clear alarm with the RESET key in all channels. Restart part program.


© Siemens AG 2005 All Rights Reserved


1-2670