Axis %1 drive %2 submodule with integrated linearization invalid
%1 = NC axis number %2 = Drive number
If a submodule with integrated linearization is used, all submodules on the module must use the integrated linearization. A submodule with integrated lineearization was found. However, not all submodules have this linearization.
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Replace the submodule.
Switch control OFF - ON.
© Siemens AG 2005 All Rights Reserved